Armytek Parma C2IR PRO weapon flashlight

Armytek Parma C2IR PRO Armytek Parma C2IR PRO is a high-quality tactical flashlight with IR illumination, which you can easily attach to the Picatinny rail on your weapon without the need for additional tools. It will be appreciated especially by professionals from the armed forces, but also by hunters. The powerful LED produces white light with a power of 1250 lumens with a range of up to 320 meters. The infrared IR illumination has a wavelength of 940 nm and is invisible to the human eye, so it will not reveal your position. In combination with night vision, you will gain a huge advantage. We cannot forget the strobe mode, which with its full power of 1250 lm can reliably dazzle and confuse any attacker. The supplied Li-Ion 18650 battery is used for power supply. If necessary, you can replace it with two CR123A batteries, but these are no longer included in the package. The flashlight can run at full power for 1 hour and 50 minutes in the default mode (after 1 minute it automatically switches to 600 lm), 2 hours and 40 minutes in strobe mode (after 1 minute it automatically switches to 600 lm) and 2 hours in IR illumination mode. To switch between the individual modes, a practical remote switch with very easy control is used. This model is highly durable and can easily withstand rough handling in the most difficult field conditions. The body made of aircraft aluminum with an anodized surface is complemented by a lens made of tempered glass with an anti-reflective coating. The flashlight meets the IP68 protection level and can therefore easily withstand immersion to a depth of two meters for 5 hours or a fall from a height of 10 m. Main advantages – Luminous flux 1250 lm – 940 nm IR illumination – Strobe mode – Easy mounting on a Picatinny rail – Remote switch – High resistance (IP68) Package contents – Flashlight – 1x Li-Ion 18650 3500 mAh battery – Remote switch – 2x switch holders for Picatinny rail – Velcro tape for attaching the switch – Switch connector cover plate – 3x screws for mounting the switch – 2x cable ties – 15mm HEX wrench – Spare O-ring